- #CISCO RECEIVER IS GETTING AIS IN TS16 SOFTWARE LICENSE#
- #CISCO RECEIVER IS GETTING AIS IN TS16 SERIAL#
- #CISCO RECEIVER IS GETTING AIS IN TS16 MANUAL#
Move the equipment farther away from the television or radio. Move the equipment to one side or the other of the television or radio. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures: Turn the television or radio antenna until the interference stops. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. You can determine whether your equipment is causing interference by turning it off.
In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense. Modifying the equipment without Cisco s written authorization may result in the equipment no longer complying with FCC requirements for Class A or Class B digital devices. However, there is no guarantee that interference will not occur in a particular installation.
These specifications are designed to provide reasonable protection against such interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules. If it is not installed in accordance with Cisco s installation instructions, it may cause interference with radio and television reception.
#CISCO RECEIVER IS GETTING AIS IN TS16 MANUAL#
The following information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency energy.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules.
#CISCO RECEIVER IS GETTING AIS IN TS16 SOFTWARE LICENSE#
IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARNTY, CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY. THE SOFTWARE LICENSE AND LIMITED WARNTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPOTED HEREIN BY THIS REFERENCE. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS. ALL STATEMENTS, INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCUTE BUT ARE PRESENTED WITHOUT WARNTY OF ANY KIND, EXPRESS OR IMPLIED. 170 West Tasman Drive San Jose, CA USA Tel: NETS (6387) Fax: Text Part Number:ΔΆ THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE.
#CISCO RECEIVER IS GETTING AIS IN TS16 SERIAL#
1 E1-G.703/G.704 Serial Port Adapter (PA-4E1G-120 and PA-4E1G-75) Installation and Configuration Product Numbers: PA-4E1G-120(=) and PA-4E1G-75(=) Platforms Supported: Cisco 7200 Series, Cisco 7000 Series and Cisco 7500 Series with VIP2, Cisco ubr7200 Series Corporate Headquarters Cisco Systems, Inc.